Tutorials

ODS Routes Using 3-Axis Sensors

ODS Routes Using 3-Axis Sensors

Start a New Route. Select the machine and click on the Route icon:

The default interface is shown using a 1-axis sensor.

To use the 3-axis sensor, plug it on Port 1-3x of the 4-channel GX400 interface and click on “A3”.

To use the reference point (ODS), plug the 1-axis sensor on channel 4 and select “F”.

You see appearing C1 C2 C3 and C4 and the 3 axis for Point 1 to be recorded at the same time :

Now select the amount of time to record (default time is 3 seconds).
Place the 3-axis sensor in point 1 where the 3-axis correspond to the direction you need (Y: Horizontal, X: Vertical and Z: Axial) invert one if needed:

Place the 1-axis sensor (Reference Sensor F) in some place of the machine where there is vibration from the same machine.
Now you are ready to start recording.
Once the point 1 is recorded, move ONLY the 3-axis sensor to point 2 and record. Proceed the same way until all the points are measured.

Carlos Varguez

Recent Posts

UADY Congress

Building Tomorrow: Inspiring Future Engineers at UADY On October 9th, 10th, and 11th, Erbessd Instruments…

4 weeks ago

Vibration Beating

Understanding Vibration Beating in Vibration Analysis and Balancing In vibration analysis and balancing, certain phenomena…

1 month ago

Erbessd at the CMC Event 2024

On September 4th and 5th, we had the privilege of participating in the CMC Mexico event, held…

2 months ago

Is Your Vibration Diagnostic System a Black Box or a White Box?

Is Your Vibration Diagnostic System a Black Box or a White Box? - The Case…

3 months ago

Phantom of the Thames: Five Years of Wireless Condition Monitoring by Erbessd-Instruments

Phantom of the Thames: Five Years of Wireless Condition Monitoring by Erbessd-Instruments The history of…

4 months ago

Remote monitoring in predictive maintenance: Improving Machine Health

Optimize machine performance with remote monitoring and predictive maintenance. Reduce downtime, enhance productivity, and extend…

6 months ago